Quick Answer: Are Both Water Heater Elements The Same?

Do water heaters have 2 elements?

Many modern homes come with dual-element water heaters.

A dual-element water heater uses two heating elements controlled by two separate thermostats.

The upper element heats the upper portion of the water column..

Why does my water heater only have one element?

A dual element water heater is a two thermostat system, an upper and lower, that heats water in its tank one element at a time. … Only one heating element will be active at any one time. Water is more evenly heated in this system, which is now the most common in homes built today.

Will a hot water heater work with only one element?

So, can you run a water heater with only one element? Yes, a water heater can still run if the bottom element quits. However, the water heater won’t run efficiently and likely won’t produce enough hot water to satisfy your family’s needs running on just the top element.

Are water heater elements Universal?

There are three types: screw in, bolt in and clamp in. They all have different wattage ratings and can work on either 120 or 240 voltage.

Can I replace a 3500 Watt water heater with a 4500 Watt?

When selecting element, buy same wattage or less wattage… keep volts the same. It is ok to install higher watt up to 5500 on 4500 watt heater if breaker is 30 amp and wire is 10 gauge. It is ok to install lower watt: replace 4500 with 3500 as long as voltage is same.

Does water heater element length matter?

Does the length of a water heater heating element make a difference? No, not as long as you have the proper voltage, watts and style. Shorter elements have a larger diameter therefore the same surface area.

Which element heats first on water heater?

The upper thermostat first sends electrical energy to the upper element until the water temperature in the upper third of the tank reaches the thermostat setting. Power is then transferred to the lower element until the remaining water reaches the lower thermostat setting.

What happens when a heating element goes out in a water heater?

If you have an electric water heater, the heating elements inside the tank can break and lead to a loss of hot water. Sometimes, your water will slowly start to cool down and this could be because the element has burned out. If the second element fails, you’ll be left with only cold water.

What causes a heating element to burn out in a water heater?

The most common cause of burned out elements on new water heater installations or new element replacements is DRYFIRE. This happens because the installer fails to open a hot water faucet while the heater tank is filling with water and therefore purging or bleeding air from the system.

Are upper and lower water heater elements the same?

The top and bottom elements are controlled by separate thermostats. When the water on the top of the tank is hot, the top element turns off and the lower one heats. The upper and lower heating elements never come on at the same time.

Will a bad water heater element use more electricity?

1.) Faulty equipment: The two biggest electrical loads in most households are the A/C system and the hot water heater. … If the elements are dirty or there is an excess buildup of sediment in the tank, the hot water heater will use a lot more energy to maintain the same tank temperature.

Can you wire a hot water heater backwards?

By reversing these connection, you are switching the neutral . The ungrounded side of the circuit ( hot) is connected to the heater and can only be interrupted by the circuit breaker .

Can you change a water heater element without draining the tank?

If you need to replace the heating element in your electric water heater, you may be thinking that you need to first drain the tank. … If the gasket sticks,remove the new gasket from the replacement element and re-use the old gasket. NOTE: You can not drain a heater from the high temp pop valve.